Silverado 1500 2WD V8-4.8L VIN V (2006)
8. Install the rear axle fill plug.
^
Tighten the rear axle fill plug to 33 Nm (24 ft. lbs.).
Notice: Refer to Fastener Notice.
9. Lower the vehicle.
Lubricant Replacement - Rear Drive Axle (8.6 Inch Axle)
Lubricant Replacement - Rear Drive Axle (8.6 Inch Axle)
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the rear axle fill plug.
3. Remove the rear axle housing cover bolts (1). Discard the rear axle housing cover bolts.
4. Carefully remove the rear axle housing cover (2) and drain the lubricant into a suitable container.
5. Remove any gasket material from the rear axle housing and/or the rear axle housing cover.
6. Inspect the bottom of the rear axle housing for excessive metal particle accumulation. This accumulation is an indication of extreme wear.
Installation Procedure
1. Install a new gasket and the rear axle housing cover (2).
