Silverado 1500 2WD V8-4.8L VIN V (2006)
5. Remove the EVAP canister purge solenoid (3) and insulator (1).
INSTALLATION PROCEDURE
1. Install the insulator (1) onto the EVAP canister purge solenoid (3).
2. Install the EVAP canister purge solenoid (3).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the EVAP canister purge solenoid bolt (2).
Tighten the bolt to 10.5 N.m (93 lb in).
4. Connect the EVAP canister purge solenoid electrical connector (1).
5. Install the EVAP line to the canister purge solenoid (1).
6. Install the engine sight shield.
