Silverado 1500 2WD V8-4.8L VIN V (2006)
4. Remove the SIR fuse from the fuse block.
IMPORTANT: With the SIR fuse removed and the ignition ON, the AIR BAG indicator illuminates. This is normal operation and does not indicate
an SIR system malfunction.
5. Remove the connector position assurance (CPA) (1) from the steering wheel module yellow 4-way connector (2) located left of the steering
column near the knee bolster.
6. Disconnect the steering wheel module yellow 4-way connector (2).
7. Remove the CPA from the instrument panel (I/P) module yellow 4-way connector (1) located behind the I/P support.
8. Disconnect the I/P module yellow 4-way connector (1).
ENABLING PROCEDURE
1. Remove the key from the ignition.
2. Connect the steering wheel module yellow 4-way connector (2) located left of the steering column near the knee bolster.
3. Install the CPA (1) to the steering wheel module yellow 4-way connector (2).
4. Connect the I/P module yellow 4-way connector (1) located behind the I/P support.
5. Install the CPA to the I/P module yellow 4-way connector (1).
6. Install the SIR fuse to the fuse block.
7. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
1. The AIR BAG indicator will flash 7 times.
2. The AIR BAG indicator will then turn OFF.
8. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information, if the AIR BAG indicator does not operate as described.
