Silverado 1500 2WD V8-4.8L VIN V (2006)
Seat Belt Latch: Service and Repair
Rear (Extended Cab)
SEAT BELT BUCKLE AND LATCH REPLACEMENT - REAR (EXTENDED CAB)
CAUTION: To avoid personal injury to the occupants of the vehicle, observe the following precautions:
-
More than one supplier's seat belts are used, therefore, install ONLY the seat belt components specified in the GM parts catalog.
-
To verify that the correct seat belt components were installed, insert the seat belt latch in the seat belt buckle. The latch must be fully
seated and be retained in the buckle until purposely released.
Removal Procedure
1. Pull the seat belt buckles through the rear seat cushion.Fold the rear seat up.
2. Remove the rear seat belt buckle nuts.
3. Remove the buckle assembly.
Installation Procedure
1. Position the buckle assembly to the floor panel stud.
2. Install the rear seat belt buckle nuts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the nuts to 53 N.m (39 lb ft).
3. Fold the rear seat down.
4. Pull the seat belt buckles through the seat cushion.
