Silverado 1500 2WD V8-4.8L VIN V (2006)
Seat Belt Retractor: Service and Repair
Rear (Crew Cab)
SEAT BELT RETRACTOR REPLACEMENT - REAR (CREW CAB)
CAUTION: To avoid personal injury to the occupants of the vehicle, observe the following precautions:
-
More than one supplier's seat belts are used, therefore, install ONLY the seat belt components specified in the GM parts catalog.
-
To verify that the correct seat belt components were installed, insert the seat belt latch in the seat belt buckle. The latch must be fully
seated and be retained in the buckle until purposely released.
Removal Procedure
1. Remove the rear seat, if required.
2. Remove the rear quarter trim panel.
3. Remove the rear seat belt to body bolts.
4. Remove the rear seat belt retractor to body bolt (1).
5. Remove the retractor from the vehicle.
Installation Procedure
1. Install the retractor to the vehicle.
2. Install the rear seat belt retractor to body bolt (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolt to 53 N.m (39 lb ft).
3. Install the rear seat belt to body bolts.
Tighten the bolts to 53 N.m (39 lb ft).
4. Install the rear quarter trim panel.
5. Install the rear seat, if removed.
