Power Steering Cooler Pipe/Hose Replacement (With Hydroboost)
3. Install the booster outlet hose to the power steering pump nipple (5) and retaining clamp.
4. Install the booster inlet hose (1) to the booster.
5. Install the gear inlet hose to the booster.
^
Tighten both power steering inlet hose fittings to 32 Nm (24 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the booster outlet hose (3) to the booster and install the retaining clamp (2).
7. Remove the drain pan from under the vehicle.
8. Bleed the power steering system.
9. Connect the energy storage box after servicing the vehicle.
Power Steering Hose Assembly Replacement (Rack and Pinion
Power Steering Hose Assembly Replacement (Rack and Pinion)
Removal Procedure
1. Disconnect the energy storage box before servicing the vehicle.
