Silverado 1500 2WD V8-4.8L VIN V (2006)
1. Route the hose in the same position the hose occupied prior to removal.
Notice: The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation
easier. Failure to follow these procedures could result in component damage.
2. Install the brake booster outlet hose (1) to the brake booster (2). Position the clamp at the end of the hose.
3. Install the brake booster outlet hose to the power steering pump (4). Position the clamp at the end of the hose.
4. Remove the drain pan from under the vehicle.
5. Bleed the power steering system.
(Non Rack and Pinion)
Power Steering Hose Assembly Replacement (Non Rack and Pinion)
Removal Procedure
1. Disconnect the energy storage box before serving the vehicle.
2. Install a drain pan under the vehicle.
Notice:
Refer to Power Steering Hose Disconnected Notice in Service Precautions.
3. Remove the power steering gear inlet hose (4) from the brake booster.
4. Remove the power brake booster outlet hose (3) retaining clamp (2) to remove the power brake booster hose outlet hose from the brake booster.
5. Remove the power brake booster inlet hose (1) from the brake booster.
