Silverado 1500 2WD V8-4.8L VIN V (2006)
^
Position the mounting/dismounting head 180 degrees from the valve stem.
^
Position the bead transition area 45 degrees counter clockwise of the valve stem.
^
Using the tire machine, rotate the tire/wheel assembly clockwise when transferring the tire bead to the inside of the wheel rim.
^
Repeat items for outer bead.
5. Install the tire/wheel assembly on the vehicle.
Important: A service replacement tire pressure sensor is shipped in OFF mode. In this mode the sensor's unique identification code cannot be
learned into the passenger door modules (PDMs) memory. The sensor must be taken out of OFF mode by spinning the tire/wheel assembly above
32 km/h (20 mph) in order to close the sensors internal roll switch for at least 10 seconds.
6. Lower the vehicle.
7. Learn the tire pressure sensors.
