Silverado 1500 2WD V8-4.8L VIN V (2006)
1. Install J 25025 into the valve body bolt hole where the manual shaft detent roller and spring is mounted.
2. Install the valve body gasket (2) onto the accumulator housing (1).
3. Install the valve body spacer plate (3) onto the valve body gasket (2).
4. Install the third and fourth clutch accumulator housing gasket (3).
5. Install the third clutch accumulator piston spring (1). This spring is the longer of the two springs.
6. Install the fourth clutch accumulator piston spring (4).
7. Install the third and fourth clutch accumulator housing assembly (5) onto the control valve body assembly (2).
8. Install the six accumulator housing bolts (6). Start the bolts finger tight and work towards the opposite end.
9.Tighten the accumulator housing bolts sequentially.
^
Tighten the bolts to 11 Nm (97 inch lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
10. Remove the J 25025.
11. Install the valve body.
