Silverado 1500 2WD V8-4.8L VIN V (2006)
4. Install the reverse signal pipe. Install the 2 bolts that fasten reverse signal pipe to the control valve assembly.
^
Tighten the bolts to 12 Nm (108 inch lbs.).
5. Reconnect the internal wiring harness to the solenoid.
6. Install the oil pan and transmission internal oil filter.
Control Valve Solenoid Replacement (SS1, SS2, SS3, TCC, and Main MOD)
Control Valve Solenoid Replacement (SS1, SS2, SS3, TCC, and MAIN MOD)
Removal Procedure
1. Remove the oil pan and the transmission internal oil filter.
2. Disconnect the internal wiring harness from the solenoid being changed.
3. Remove the solenoid retainer (2) for shift solenoid 1 (SS1) (5). Note the position of the solenoid connector and pull the solenoid (5) out of the
bore in the control valve assembly (1). The O-rings (3 and 4) provide the resistance felt during removal.
