Silverado 1500 2WD V8-4.8L VIN V (2006)
Important:
^
Do not reuse any of the existing oil lines or oil line fittings if there is excessive corrosion.
^
Do not reuse any of the existing retaining rings that were removed from the existing quick connect fittings. All retaining rings being installed
must be new.
^
Ensure the following procedures are performed when installing the new retaining rings onto the fittings.
3. Hook one of the open ends of the retaining ring in one of the slots in the quick connect fitting.
4. Rotate the retaining ring around the fitting until the retaining ring is positioned with all three ears through the three slots on the fitting.
5. Do not install the new retaining ring onto the fitting by pushing the retaining ring.
6. Ensure that the three retaining ring ears are seen from inside the fitting and that the retaining ring moves freely in the fitting slots.
7. Install the NEW retaining ring (E-clip) into the remaining quick connect fittings.
