Silverado 1500 2WD V8-4.8L VIN V (2006)
1. Install the shift lever (1).
2. Connect the shifter electrical connector.
3. Install the wire straps to the harness.
4. Install the harness retaining pin (4) to the instrument panel.
5. Install the knee bolster deflector bracket and nuts (1).
^
Tighten the nuts to 9 Nm (80 inch lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
7. Install the TORX head shift lever screw.
^
Tighten the screw to 20 Nm (15 ft. lbs.).
8. Roll the seal over the TORX head shift lever screw.
9. Install the 2 TORX head screws to the lower column trim cover.
10. Install the trim covers.
