Silverado 1500 2WD V8-4.8L VIN V (2006)
10. Install the manual detent spring.
11. Install but do not tighten the manual detent spring bolt.
12. Install the transmission fluid pressure switch.
13. Install but do not tighten the valve body bolts which retain the transmission fluid pressure switch to the valve body.
14. Tighten the valve body bolts in a spiral pattern starting from the center, as indicated by the arrows.
^
Tighten the bolts in the sequence shown to 11 Nm (97 inch lbs.).
Notice: Torque valve body bolts in a spiral pattern starting from the center. If the bolts are torqued at random, valve bores may be distorted and
inhibit valve operation.
15. Ensure that the manual detent spring is aligned properly with the detent lever.
^
Tighten the bolt to 11 Nm (97 inch lbs.).
