Silverado 1500 2WD V8-4.8L VIN V (2006)
3. Install one bolt marked (1) to hold the control valve assembly in place.
4. Reinstall the remaining 10 bolts marked (1) and 4 bolts marked (2) that fasten the control valve assembly to the transmission case.
^
Tighten the bolts to 12 Nm (108 inch lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
5. Push the transmission main connector outward through the hole in the transmission case until the retaining feet on the connector are nearing the
locked position.
