Silverado 1500 2WD V8-4.8L VIN V (2006)
Notice: Refer to Pinion Flange/Yoke Installation Notice in Service Precautions.
5. Install the washer.
6. Install the new pinion nut
7. Install the J 8614-01 onto the pinion yoke as shown.
8. Tighten the pinion nut while holding the J 8614-01.
^
Tighten the pinion nut to 370 Nm (273 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
9. Install the propeller shaft to the rear axle pinion yoke.
10. Inspect and add axle lubricant to the axle housing, if necessary.
11. Lower the vehicle.
Rear Axle Shaft Seal and/or Bearing Replacement (W/Rear Disc)
Rear Axle Shaft Seal and/or Bearing Replacement (w/Rear Disc)
^
Tools Required
-
J 8092 Universal Driver Handle-3/4 in - 10
-
J 21128 Axle Pinion Oil Seal Installer (8.6 inch and 9.5 inch LD Axles)
-
J 23690 Axle Shaft Bearing Installer (8.6 inch and 9.5 inch LD Axles)
-
J 2619-01 Slide Hammer
-
J 29709 Wheel Bearing Installer (9.5 inch Axle)
-
J 29712 Wheel Bearing Remover (9.5 inch Axle)
