Silverado 1500 2WD V8-4.8L VIN V (2006)
-
J 29713 Axle Seal Installer (9.5 inch Axle)
-
J 44685 Rear Axle Seal and Bearing Remover (8.6 inch and 9.5 inch LD Axles)
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel assembly.
3. Remove the rear axle housing cover.
4. Remove the axle shaft.
5. Remove the axle shaft seal and the bearing from the axle housing using the J 44685 (8.6 inch and 9.5 inch LD axles) (1) and the J 2619-01 (2).
6. Remove the axle shaft seal and the bearing from the axle housing using the J 29712 (9.5 inch axle).
Installation Procedure
1. Install the axle shaft bearing using the J 23690 (8.6 inch and 9.5 inch LD axles) (1) or the J 29709 (9.5 inch axle) (1) and the J 8092 (2).
2. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
