Silverado 1500 2WD V8-4.8L VIN V (2006)
6. On axles with a locking differential, place the C-lock (1) on the axle shaft (3) so that the ends are flush with the thrust block (2).
7. Pull the shaft flange outward in order to seat the lock in the differential gear.
8. Align the hole in the pinion shaft with the bolt hole in the differential case.
9. Install the new pinion shaft locking bolt.
^
Tighten the bolt to 34 Nm (25 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
10. Install the rear cover and the gasket.
11. Install the tire and wheel assembly.
12. Fill the rear axle, using the proper fluid. Refer to Capacities - Approximate Fluid and Fluid and Lubricant Recommendations.
13. Lower the vehicle.
Rear Axle Shaft Replacement (8.6, 9.5/9.5LD Inch Axles)
Rear Axle Shaft Replacement (8.6, 9.5/9.5LD Inch Axles)
Removal Procedure
