Silverado 1500 2WD V8-4.8L VIN V (2006)
1. Using J 22834-A install the NEW rear oil seal.
2. If required, install the following:
1. The yoke
2. A NEW main shaft washer
3. A NEW prop shaft yoke washer
4. The main shaft nut
3. If required, use J 8614-01 in order to keep the keep yoke from rotating.
Notice: Refer to Fastener Notice in Service Precautions.
4. Tighten the main shaft nut.
^
Tighten the nut to 441 Nm (325 ft. lbs.).
5. Install the rear propeller shaft.
6. Check the transmission fluid level. Add if necessary.
