Silverado 1500 2WD V8-4.8L VIN V (2006)
3. Position the clutch actuator cylinder.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the clutch actuator cylinder bolts.
^
Tighten the bolts to 8 Nm (71 inch lbs.).
5. Install the transmission.
6. Install the rear propeller shaft.
7. Check the transmission fluid level. Add if necessary.
8. Lower the vehicle.
Transmission Output Shaft Seal Replacement
Transmission Output Shaft Seal Replacement
^
Tools Required
-
J 6125-1B Slide Hammer
-
J 44732 Output Shaft Oil Seal Installer
-
J 23129 Universal Seal Remover
-
J 8614-01 Pinion Flange Holder
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the rear propeller shaft.
3. Using the J 8614-01 to hold the transmission yoke, remove and discard the yoke nut.
4. Remove the yoke.
