Silverado 1500 2WD V8-4.8L VIN V (2006)
7. Verify that the manual valve link (3) is installed properly to the inside detent lever (1) and the manual valve (2).
8. Install one bolt (M6 X 1.0 X 47.5) hand tight in the center (1) of the valve body to hold it in place.
9. Do not install the transmission fluid indicator stop bracket and bolt at this time. Install but do not tighten the valve body bolts which retain only the
valve body directly. Each numbered bolt location corresponds to a specific bolt size and length, as indicated by the following:
^
M6 X 1.0 X 65.0 (1)
^
M6 X 1.0 X 54.4 (2)
^
M6 X 1.0 X 47.5 (3)
^
M6 X 1.0 X 35.0 (4)
^
M8 X 1.0 X 20.0 (5)
^
M6 X 1.0 X 12.0 (6)
^
M6 X 1.0 X 18.0 (7)
Important: When installing bolts throughout this procedure, be sure to use the correct bolt size and length in the correct location as specified.
