Silverado 1500 2WD V8-5.3L (2007)
Perform the Diagnostic Repair Verification after completing the diagnostic procedure. See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests and Procedures
*
Steering Wheel Control Switch Assembly Replacement
*
Programming and Relearning for BCM setup, and programming. See: Testing and Inspection/Programming and Relearning
Cruise Control Switch Indicator Inoperative
Cruise Control Switch Indicator Inoperative
Diagnostic Instructions
*
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. See: Testing and Inspection/Initial Inspection and
Diagnostic Overview/Diagnostic System Check - Vehicle
*
Review Strategy Based Diagnosis for an overview of the diagnostic approach.
*
Diagnostic Procedure Instructions provides an overview of each diagnostic category.
Circuit/System Description
The body control module (BCM) monitors the cruise control indicator switch. When the cruise on/off switch is pressed ON, the cruise control switch is
closed and the signal circuit is low. When the cruise on/off switch is pressed OFF, the cruise control switch is open and the signal circuit is high.
Circuit/System Testing
1. Ignition OFF, disconnect the cruise control switch assembly.
2. Connect a fused jumper between the voltage signal circuit and the low reference circuit.
3. Ignition ON, observe the Cruise On/Off Switch parameter.
‹› If the Cruise On/Off Switch parameter displays ON, replace the cruise control switch assembly.
‹› If the Cruise On/Off Switch parameter displays Off, test the voltage signal circuit and the low reference circuit for an open, or for a high
resistance.
4. If all circuits test normal, replace the BCM.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure. See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests and Procedures
*
Steering Wheel Control Switch Assembly Replacement
*
Programming and Relearning for setup, and programming. See: Testing and Inspection/Programming and Relearning