Silverado 1500 2WD V8-5.3L VIN T (2005)
Fuel Return Line: Service and Repair
Fuel Hose/Pipes Replacement - Chassis (Pickup)
FUEL HOSE/PIPES REPLACEMENT - CHASSIS (PICKUP)
REMOVAL PROCEDURE
IMPORTANT: Clean the fuel and evaporative emission (EVAP) connections and surrounding areas prior to disconnecting the lines in order to avoid
possible system contamination.
1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
2. Disconnect the fuel feed line (1) at the engine.
3. Disconnect the EVAP canister purge tube line (2).
4. Cap the fuel rail and EVAP lines in order to avoid possible system contamination.
5. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
6. Remove the fuel pipe bracket nut.
7. Remove the fuel pipe bracket from the bellhousing stud.
8. Remove the heated oxygen sensor (HO2S) sensor connector from the bracket.
