Silverado 1500 2WD V8-5.3L VIN T (2005)
7. Remove the steering knuckle (2) from the vehicle.
Installation Procedure
1. Install the steering knuckle (2) to the vehicle.
2. Install the upper ball joint.
3. Install the lower ball joint.
4. Notice: Refer to Fastener Notice in Service Precautions.
Install the park brake cable retaining bolt (3) to the steering knuckle.
^
Tighten the bolt to 65 Nm (48 ft. lbs.).
5. Install the wheel hub and bearing.
6. Install the outer tie rod retaining nut (1).
^
Tighten the nut to 55 Nm (40 ft. lbs.).
7. Install the tire and wheel.
8. Perform a four wheel alignment.
