Silverado 1500 2WD V8-6.0L (2010)
3. Position the park brake pedal assembly on the side panel.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install and finger tighten the mounting nuts. Tighten the nuts to 25 Nm (18 lb ft).
5. Connect the park brake warning lamp connection.
6. Install the park brake release handle to the instrument panel.
7. Install the park brake release handle bolt and tighten to 9 Nm (80 lb in).
8. Install the hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement (See: Body and Frame/Interior Moulding / Trim/Trim
Panel/Service and Repair/Body Hinge Pillar Trim Panel Replacement).
9. Install the left side instrument panel electrical center/junction block. Refer to Instrument Panel Electrical Center or Junction Block Replacement -
Left Side (See: Maintenance/Fuses and Circuit Breakers/Fuse Block/Service and Repair/Removal and Replacement/Instrument Panel Electrical
Center or Junction Block Replacement - Left Side).
10. Raise the vehicle.
