Silverado 1500 2WD V8-6.0L (2010)
1. Install a NEW valve lifter oil filter O-ring seal (4) into the valve lifter oil manifold.
2. Install the NEW valve lifter oil filter (3).
3. Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the threads of the oil pressure sensor.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the oil pressure sensor washer (2) and sensor (1).
Tighten the sensor to 35 Nm (26 lb ft).
5. Connect the engine harness electrical connector (1) to the oil pressure sensor.
6. Install the intake manifold. Refer to Intake Manifold Replacement (Without AFM) (See: Intake Manifold/Service and Repair)Intake Manifold
Replacement (With AFM) (See: Intake Manifold/Service and Repair).
