Silverado 1500 2WD V8-6.0L (2010)
14. If replacing the exhaust manifold, remove the exhaust manifold heat shield bolts, and shield from the exhaust manifold.
Installation Procedure
Note:
*
Tighten the exhaust manifold bolts as specified in the service procedure. Improperly installed and/or leaking exhaust manifold gaskets may affect
vehicle emissions and/or On-Board Diagnostic (OBD) II system performance.
*
The cylinder head exhaust manifold bolt hole threads must be clean and free of debris or threadlocking material.
*
Do not apply sealant to the first 3 threads of the bolt.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. If the exhaust manifold was replaced, position and install the exhaust manifold heat shield, and bolts to the exhaust manifold.
Tighten the bolts to 9 Nm (80 lb in).
