Silverado 1500 2WD V8-6.0L (2010)
Power Brake Booster Outlet Hose Replacement
Power Brake Booster Outlet Hose Replacement
Removal Procedure
1. Place drain pans under the vehicle as needed.
2. Remove as much power steering fluid from the power steering fluid reservoir as possible.
Caution: Refer to Power Steering Hose Disconnected Caution (See: Service Precautions).
3. Disconnect the power brake booster outlet hose (1) from the power brake booster (2).
4. Disconnect the power brake booster outlet hose (1) from the power steering fluid reservoir (3).
5. Remove the power brake booster outlet hose (1) from the vehicle.
Installation Procedure
Caution: The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation
easier. Failure to follow these procedures could result in component damage.
1. Install the power brake booster outlet hose (1) to the vehicle.
2. Connect the power brake booster outlet hose (1) to the power steering fluid reservoir (3).
3. Connect the power brake booster outlet hose (1) to the power brake booster (2).
4. Clean any excess fluid from the vehicle and remove the drain pans.
5. Fill and bleed the power steering system. Refer to Power Steering System Bleeding (See: Steering and Suspension/Steering/Power
Steering/Power Steering Bleeding/Service and Repair).
