Silverado 1500 2WD V8-6.0L (2010)
Installation Procedure
1. Install the air cleaner outlet duct to the throttle body and MAF/IAT sensor. Ensure that the resonator tab aligns with the stud on the intake
manifold.
2. Push down on the air cleaner outlet duct resonator directly over the resonator tab in order to secure the resonator to the stud on the intake
manifold.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution)
3. Tighten the air cleaner outlet duct clamp (2) at the throttle body to 4 Nm(35 lb in).
4. Tighten the air cleaner outlet duct clamp (1) to 4 Nm(35 lb in) at the MAF/IAT sensor.
5. Install the radiator inlet hose clamp retainer to the outlet duct.
6. Install the PCV line (1) to the air cleaner outlet duct.
7. Install the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (See: Engine, Cooling and
Exhaust/Engine/Intake Manifold/Service and Repair).
