Silverado 1500 2WD V8-6.0L (2010)
*
A flush rotor flange cuff (4)
Note: If you are reusing the existing sensor, make an alignment mark (3) on the rotor flange cuff before removing the sensor. Failure to do so will
cause misalignment of the old sensor. Replace a misaligned sensor with a new sensor.
8. Make an alignment mark on the flush rotor flange cuff.
9. Remove the connector from the sensor.
10. Remove the sensor from the adapter and bearing assembly.
11. To install the sensor, proceed to step 4 in the installation procedure.
12. From the technicians point of view, the FRONT of the sensor will have:
*
A raised rotor flange cuff (3)
*
An alignment mark (2) on the rotor flange cuff for installation
*
A pin hole (1) for the centering pin-Note the location of the pin hole.
13. Remove the connector from the sensor.
14. Remove the sensor from the adapter and bearing assembly.
15. To install the sensor, proceed to step 8 in the installation procedure.
16. From the technicians point of view, the FRONT of the sensor will have:
*
A raised rotor flange cuff (3)
*
An alignment mark (2) on the rotor flange cuff for installation
*
A pin hole (1) for the centering pin-Note location of the pin hole.
*
A sensor clip in FRONT of the sensor
17. Remove the connector from the sensor.
18. Remove the sensor clip from the sensor.
19. Remove the sensor from the adapter and bearing assembly.
20. To install the sensor, proceed to step 12 in the installation procedure.
