Silverado 1500 2WD V8-6.0L (2010)
21. From the technicians point of view, the FRONT of the sensor will have:
*
A flush rotor flange cuff (3)
*
A pin hole (1) for the centering pin-Note the location of the pin hole.
*
An alignment mark (2) on the flush rotor flange cuff for installation
22. Remove the connector from the sensor.
23. Remove the sensor from the adapter and bearing assembly.
24. To install the sensor, proceed to step 16 in the installation procedure.
25. From the technicians point of view, the FRONT of the sensor will have:
*
A flush rotor flange cuff (4)
*
A pin hole (2) for the centering pin-Note the location of the pin hole.
*
An alignment mark (3) on the flush rotor flange cuff for installation
*
A foam ring (1)
26. Remove the connector from the sensor.
27. Remove the sensor from the adapter and bearing assembly.
28. To install the sensor, proceed to step 20 in the installation procedure.
Installation Procedure
Note: If you are reusing the existing sensor, centering of the old sensor is not necessary.
If you are installing a new sensor, the new sensor will come with a pin. Do not remove the pin until the sensor is seated.
1. From the technicians point of view of the FRONT of the sensor (1), the connector will be on your right.
