Silverado 1500 2WD V8-6.0L Hybrid (2009)
Cruise Control: Testing and Inspection
Cruise Control Indicator Malfunction (Switch Indicator Malfunction)
Cruise Control Indicator Malfunction (Switch Indicator Malfunction)
Diagnostic Instructions
*
Perform theDiagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
*
ReviewStrategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
*
Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure Instructions)
provides an overview of each diagnostic category.
Diagnostic Fault Information
Circuit/System Description
The cruise control switch contains an LED that illuminates to indicate the cruise control system has been switched ON. Voltage is applied through the
ON/OFF switch to the LED when the switch is pressed. The BCM provides the ground path for the LED through a dedicated control circuit. Pressing the
switch again opens the switch and the lamp turns OFF.
Reference Information
Schematic Reference
Cruise Control Schematics (See: Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
*
Cruise Control Description and Operation (See: Description and Operation)
*
Indicator/Warning Message Description and Operation (See: Instrument Panel, Gauges and Warning Indicators/Description and
Operation/Indicator/Warning Message Description and Operation)
Electrical Information Reference
*
Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Ignition ON, observe the cruise control indicator while applying the cruise On/Off switch. The indicator should turn on and off accordingly with the
applied switch.
Circuit/System Testing
Important: Refer to DTC B3794 (See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code
Tests and Associated Procedures/B Code Charts/B3794) before performing this diagnostic, if this code is set as current or history.
