Silverado 1500 2WD V8-6.0L Hybrid (2009)
5. Apply threadlock to the threads of the ignition coil bracket studs. Refer to Adhesives, Fluids, Lubricants, and Sealers (See:
Specifications/Adhesives, Fluids, Lubricants, and Sealers) .
6. Position the ignition coil bracket (719) onto the rocker cover.
7. Install the ignition coil bracket studs (720).
Tighten the studs to 12 Nm (106 lb in).
8. Install the spark plug wires (724) to the ignition coils.
9. Position the engine harness, as necessary.
10. Install two engine harness clips (4) to the ignition coil bracket studs.
11. Connect the engine harness electrical connector (1) to the ignition coil wire harness.
12. Install the CPA retainer (2).
13. Install the intake manifold cover. Refer to Upper Intake Manifold Sight Shield Replacement (See: Intake Manifold/Service and Repair) .
