Silverado 1500 2WD V8-6.0L Hybrid (2009)
2. Obtain a revised wiring harness clip (Warranty Parts Center (WPC) # 577) from the WPC. Refer to Parts Information below.
3. Insert the motor harness (minus the two separate brown wires) into the revised wiring harness clip.
4. Position the two brown wires into the access slot (1) located on the internal side of the wiring harness clip.
5. Engage the locking tab (1) to retain the harness within the clip.
6. Install the wiring harness clip back into the motor housing. The drive motor is now ready to be installed into the transmission case.
Parts Information
To obtain the revised wiring harness clip, fax the form included in this bulletin to the GM Warranty Parts Center (WPC). Request WPC#577 for the
wiring harness clip.
