Silverado 1500 2WD V8-6.0L Hybrid (2009)
6. Install the sight shield circuit breaker (2) and secure with bolts (1). Tighten the bolts to 5 Nm (44 lb in) .
7. Connect the APM assembly connectors (1 and 3) and install any removed locking tabs.
8. Connect the APM assembly connector (2) using the following procedure:
1. Push the lever up.
Note
Install the connector (2) without disturbing the position of the lever. DO NOT use the lever to install the connector in place.
2. Install the connector (2) onto the terminals by pushing on the connector only.
3. Rotate the lever after the terminals are engaged.
4. Push the green tab to lock the lever.
