Silverado 1500 2WD V8-6.0L Hybrid (2009)
6. Using a suitable tool, at the center of the rod, bend one leg of the rod towards the center as shown (1). The object is to make one end of the "U"
shaped section of the rod close to a 90 degree bend. Take care not the twist the rod as you bend it.
7. Using the same tool, straighten the rod at the other bend shown (1) until the rod is back straight. Take care not to twist the rod as you bend it.
8. Inspect the rod standing up on a flat surface as shown. The rod should rest flat on the surface. Minor gapping (1) on the bent leg is acceptable.
9. Inspect the rod laying flat on a flat surface as shown. The rod should rest flat on the surface. Minor gapping (1) on the bent leg is acceptable.
10. Inspect the overall length of the rod as shown. The overall length of the rod should be 3-4 mm (0.118-0.157 in) shorter. If the length is not correct,
rebend the rod using the steps above to achieve the correct length.
