chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Electrical - MIL ON/DTC's Set By Various Control Modules|Page 238 > < Parking Assist System - 'Park Assist Off' Message on DIC|Page 229
Page 1
background image

Relay Module: Customer Interest
Electrical - MIL ON/DTC's Set By Various Control Modules

TECHNICAL

Bulletin No.: 09-06-03-004D

Date: December 08, 2010

Subject: Intermittent No Crank/No Start, No Module Communication, MIL, Warning Lights, Vehicle Messages or DTCs Set by Various Control
Modules - Diagnosing and Repairing Fretting Corrosion (Disconnect Affected Connector and Apply Dielectric Lubricant)

Models:

2011 and Prior GM Passenger Cars and Trucks 

Attention:

This repair can be applied to ANY electrical connection including, but not limited to: lighting, body electrical, in-line connections, powertrain control
sensors, etc. DO NOT over apply lubricant to the point where it prevents the full engagement of sealed connectors. A light coating on the terminal
surfaces is sufficient to correct the condition.

Supercede:
This bulletin is being revised to update the Attention statement and add the 2011 model year. Please discard Corporate Bulletin Number 09-06-03-004C
(Section 06 - Engine/Propulsion System).

Condition

Some customers may comment on any of the following conditions:

-

An intermittent no crank/no start

-

Intermittent malfunction indicator lamp (MIL) illumination 

-

Intermittent service lamp illumination

-

Intermittent service message(s) being displayed 

The technician may determine that he is unable to duplicate the intermittent condition.

Cause

This condition may be caused by a buildup of nonconductive insulating oxidized debris known as fretting corrosion, occurring between two electrical
contact surfaces of the connection or connector. This may be caused by any of the following conditions: 

-

Vibration 

-

Thermal cycling 

-

Poor connection/terminal retention

-

Micro motion 

-

A connector, component or wiring harness not properly secured resulting in movement 

On low current signal circuits this condition may cause high resistance, resulting in intermittent connections.

On high current power circuits this condition may cause permanent increases in the resistance and may cause a device to become inoperative.

Representative List of Control Modules and Components

The following is only a representative list of control modules and components that may be affected by this connection or connector condition and DOES
NOT 
 include every possible module or component for every vehicle. 

-

Blower Control Module 

-

Body Control Module (BCM) 

-

Communication Interface Module (CIM) 

-

Cooling Fan Control Module 

-

Electronic Brake Control Module (EBCM) 

-

Electronic Brake and Traction Control Module (EBTCM) 

-

Electronic Suspension Control (ESC) Module 

-

Engine Control Module (ECM) 

-

Heating, Ventilation and Air Conditioning (HVAC) Control Module 

Electrical - MIL ON/DTC's Set By Various Control Modules|Page 238 > < Parking Assist System - 'Park Assist Off' Message on DIC|Page 229