Silverado 1500 2WD V8-6.0L Hybrid (2009)
1. Install the wheel speed sensor ring using the J-45860 - Tone Ring Installer (1) and the J-8092 - Driver Handle (2).
2. Drive the wheel speed sensor ring into the axle housing until the tool bottoms against the tube.
3. Install the axle shaft bearing using the J-23690 - Bearing Installer (1) and the J-8092 - Driver Handle (2).
4. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
5. Install the axle shaft seal using the J-21128 - Axle Pinion Oil Seal Installer .
6. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
7. Install the axle shaft. Refer to Rear Axle Shaft Replacement (See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Axle Shaft/Service and Repair) .
8. Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement (8.6, 9.5 Inch Axles) (See: Transmission and
Drivetrain/Differential Assembly/Service and Repair/Removal and Replacement/Rear Axle Housing Cover and Gasket Replacement (8.6, 9.5 Inch
Axles))Rear Axle Housing Cover and Gasket Replacement (10.5/11.5 Inch Axle) (See: Transmission and Drivetrain/Differential
Assembly/Service and Repair/Removal and Replacement/Rear Axle Housing Cover and Gasket Replacement (10.5/11.5 Inch Axle)) .
9. Install the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement (See: Rear Wheel Speed Sensor Replacement) .
10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair) .
