Silverado 1500 2WD V8-6.0L Hybrid (2009)
1. Install the ignition lock cylinder case (1) to the vehicle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution) .
2. Install the 3 ignition lock cylinder case screws (2).
Tighten the screws to 7 Nm (62 lb in).
3. Install the park lock cable into the lock cylinder housing.
4. Connect the passlock and key buzzer to the ignition lock cylinder case.
5. Install the ignition/start switch. Refer to Ignition and Start Switch Replacement (See: Service and Repair) .
6. Install the inflatable restraint steering wheel module coil. Refer to Steering Wheel Inflatable Restraint Module Coil Replacement (See: Restraint
Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Removal and Replacement) .
Ignition Lock Cylinder Replacement
Ignition Lock Cylinder Replacement
Removal Procedure
Warning: Refer to SIR Warning (See: Restraint Systems/Service Precautions/SIR Warning) .
1. Disable the SIR system. Refer to SIR Disabling and Enabling (See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air
Bag(s) Arming and Disarming/Service and Repair) .
2. Remove the steering column shroud. Refer to Steering Column Shroud Replacement (See: Steering and Suspension/Steering/Steering
Column/Service and Repair/Steering Column Shroud Replacement) .
3. With the key installed hold it in the START position.
4. Install an allen wrench into the hole on top of the ignition lock cylinder case.
Push down on the allen wrench to release the tab on the ignition lock cylinder inside the ignition lock cylinder case.
