Silverado 1500 2WD V8-6.0L Hybrid (2009)
Ignition Switch Lock Cylinder: Removal and Replacement
Ignition Lock Cylinder Case Replacement
Ignition Lock Cylinder Case Replacement
Removal Procedure
Warning: Refer to SIR Warning (See: Restraint Systems/Service Precautions/SIR Warning) .
1. Remove the inflatable restraint steering wheel module coil. Refer to Steering Wheel Inflatable Restraint Module Coil Replacement (See:
Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Removal and Replacement) .
2. Remove the ignition/start switch. Refer to Ignition and Start Switch Replacement (See: Service and Repair) .
3. Disconnect the park lock cable from the ignition lock cylinder case.
4. Disconnect the passlock and key buzzer from the ignition lock cylinder case.
5. Remove the 3 ignition lock cylinder case screws (2).
6. Remove the ignition lock cylinder case (1) from the vehicle.
Installation Procedure
