Silverado 1500 2WD V8-6.0L Hybrid (2009)
11. Disconnect the power steering assist motor electrical connector at the torque sensor.
Note
Only remove the 2 bolts indicated in the graphic. Under NO circumstances are the power steering assist motor housing bolts to be removed or loosened.
If two or more of these bolts are removed or loosened the steering gear will need to be replaced because the steering gear housing to gear lash will be out
of specification.
12. Remove the power steering assist motor bolts (1).
Note
DO NOT remove the power steering assist motor electrical harness from the power steering assist motor. They are serviced as a unit only.
13. Remove the power steering assist motor and electrical harness (2).
14. Remove and ensure the power steering assist motor seal (3) is kept protected while out of the vehicle as it will be needed for reinstallation.
Installation Procedure
1. Install any new wiring harness retainers as needed.
