Silverado 1500 2WD V8-6.0L Hybrid (2009)
Note
If the rear axle shaft is difficult to remove, proceed to step 14.
13. Remove the rear disc brake axle shaft (1) from the rear axle assembly (2), if equipped
14. Using the J 2619-01 - hammer (2) and the J 45859 - remover/installer (1), remove the rear axle shaft from the rear axle assembly.
15. Replace the rear axle shaft seal and or bearing, if needed. Refer to Rear Axle Shaft Seal and/or Bearing Replacement (See: Axle Bearing/Service
and Repair/Rear Axle Shaft Seal and/or Bearing Replacement) .
Installation Procedure
Note
When installing the rear axle shaft, ensure that the seal is not damaged.
