Silverado 1500 2WD V8-6.0L VIN U (2004)
1. Raise and support the vehicle. Refer Vehicle Lifting
2. Remove the tire and wheel assembly.
3. Install a C-clamp over the body of the brake caliper, with the C-clamp ends against the rear of the caliper body and the outboard disc brake pad.
4. Slowly tighten the C-clamp until the pistons are pushed into the caliper bores enough to remove the caliper from the pads.
5. Remove the C-clamp from the caliper.
6. Remove the nut and the bolt from the quarter shaft shield.
7. Remove the shield.