Silverado 1500 2WD V8-6.0L VIN U (2004)
1. Install the clutch coil (6) to the A/C compressor (7).
2. Install the snap ring (5) to the clutch coil (6).
3. Install the clutch hub/bearing assembly (4).
4. Install the clutch hub/bearing snap ring (3).
5. Install the clutch plate assembly (2).
NOTE: Refer to Fastener Notice in Service Precautions.
6. Install the clutch plate retaining bolt (1).
Tighten
Tighten the bolt to 18 N.m (13 lb ft).
7. Install a ratchet into the A/C belt tensioner adapter opening.
8. Rotate the A/C belt tensioner clockwise in order to relieve the tension on the belt.
9. Install the A/C belt to the A/C compressor.
10. Slowly release the tension on the A/C belt tensioner.
11. Remove the ratchet from the A/C belt tensioner.
12. Install the engine protection shield.
13. Lower the vehicle.