Silverado 1500 2WD V8-6.2L (2010)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor Replacement
Removal Procedure
Note: Perform the Crankshaft Position System Variation Learn (See: Testing and Inspection) whenever the crankshaft position sensor is removed or
replaced.
1. Remove the starter. Refer to Starter Replacement (V8) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair)Starter
Replacement (V6) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair)Starter Replacement (6.6L) (See: Starting and
Charging/Starting System/Starter Motor/Service and Repair).
2. Working through the wheel well opening, disconnect the engine wiring harness electrical connector (1) from the crankshaft position (CKP) sensor.
3. Clean the area around the CKP sensor before removal in order to avoid debris from entering the engine.
4. Remove the CKP sensor bolt.