Silverado 1500 2WD V8-6.2L (2010)
1. Position the accelerator pedal to the accelerator pedal bracket.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the accelerator pedal bolts and tighten to 9 Nm (80 lb in).
3. Connect the APP sensor electrical connector (1).
4. Connect a scan tool to the diagnostic port in order to test for proper throttle-opening and throttle-closing range.
5. Operate the accelerator pedal and monitor the throttle angles. The accelerator pedal should operate freely, without binding, between a closed
throttle, and a wide open throttle (WOT).
6. Verify that the vehicle meets the following conditions:
*
The vehicle is not in a reduced engine power mode.
*
The ignition is ON.
*
The engine is OFF.