Silverado 1500 4WD V8-5.3L (2007)
1. Install the shock absorber.
2. Install the upper shock absorber nut and bolt.
Notice: Refer to Fastener Notice.
3. Install the lower shock absorber nut and bolt.
*
Tighten the upper shock absorber bolts to 115 N.m (85 lb ft).
*
Tighten the lower shock absorber bolts to 115 N.m (85 lb ft).
4. Remove the support from the rear axle.
5. Remove the safety stands.
6. Lower the vehicle.
Shock Absorber Disposal
Shock Absorber Disposal
Caution: Gas charged shock absorbers contain high pressure gas. Do not remove the snap ring from inside the top of the tube. If the snap ring
is removed, the contents of the shock absorber will come out with extreme force which may result in personal injury.
Caution: To prevent personal injury, wear safety glasses when centerpunching and drilling the shock absorber. Use care not to puncture the
shock absorber tube with the centerpunch.
