Silverado 1500 4WD V8-5.3L VIN T (2004)
1. Install the emblem (1) onto the grille (2).
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the retaining nuts (3) and tighten.
Tighten the retaining nuts to 3 N.m (27 lb in).
3. Reinstall the upper grille baffle.
Emblem/Nameplate Replacement - Door (W/O SS)
Emblem/Nameplate Replacement - Door (W/O SS)
Tools Required
J 25070 Heat Gun
Removal Procedure
Important: Use the tape for protection and alignment marks for alignment of the new emblem.
1. Apply tape to the area around the door emblem.
2. Heat the emblem/nameplate, using a heat gun J 25070 152 mm (6.0 in) from the surface.
3. Apply the heat using a circular motion for about 30 seconds.
Notice: Refer to Exterior Trim Emblem Removal Notice in Service Precautions.
