Silverado 1500 4WD V8-5.3L VIN T (2004)
10. Install the pressure sensor (2) to the front passenger seat frame, if equipped with the Inflatable Restraint Passenger Presence System.
11. Connect the electrical connectors.
NOTE: Refer to Fastener Notice in Service Precautions.
12. Install the front nuts (2) onto the studs on the underside of the cushion.
Tighten
Tighten the nuts to 21 N.m (15 lb ft).
13. Install the front seat trim panel.
14. Re-zero the Inflatable Restraint Passenger Presence System. Refer to Passenger Presence System Rezeroing Procedure in Restraint Systems.
Seat Cushion Frame Replacement - Rear
SEAT CUSHION FRAME REPLACEMENT - REAR
REMOVAL PROCEDURE
