Silverado 1500 4WD V8-5.3L VIN T (2004)
1. Install the upper end of the intermediate shaft into the upper shaft.
2. Install the lower end of the intermediate shaft coupler.
1. If you are reinstalling the same shaft, align the marks made during the removal procedure.
2. Install the lower end of the intermediate shaft coupler onto the steering gear worm shaft.
3. Install the bolt to the lower shaft coupler.
4. Notice:
Refer to Fastener Notice in Service Precautions.
Install the bolt to the upper end of the shaft.
^
Tighten the upper bolt to 47 Nm (35 ft. lbs.).
^
Tighten the coupler pinch bolt to 47 Nm (35 ft. lbs.).
5. For vehicles equipped with a 6.6L Diesel, remove the left charge air cooler hose.
6. Remove the J 42640 from the steering column lower access hole.
