Silverado 1500 4WD V8-5.3L VIN T (2004)
8. Remove the pinion gear bearing retainer bolts.
9. Remove the pinion gear bearing retainer and the pinion.
10. Remove the selective shim.
11. Measure the amount of torque required to rotate the pinion. Use an inch-pound torque wrench. Record this measurement for reassembly.
12. Install the J 8614-01 as shown.
13. Remove the pinion nut while holding the J 8614-01.
14. Remove the washer.
15. Install the J 8614-2 (2) and the J 8614-3 (1) into the J 8614-01 (3) as shown.
16. Remove the pinion yoke by turning the J 8614-3 (1) clockwise while holding the J 8614-01 (3).
17. Remove the pinion oil seal. Use a suitable seal removal tool. Do not damage the housing.
18. Remove the outer pinion bearing.
19. Remove the pinion.
